Altronix AL400ULM | Access Power Distribution Module w/ Power Supply/Charger, 5 PTC Class 2 Outputs, 12/24VDC @ 4A, FAI, 115VAC, BC300 Enclosure

AL400ULM multi-output access control power supply/charger is specifically designed for use with access control systems and accessories. This unit converts a 115VAC / 60Hz input into five (5) individually protected Class 2 Rated power limited 12VDC or 24VDC outputs. Each output will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. These outputs will operate in both Fail-Safe and Fail-Secure modes. Controlled trigger input is achieved through normally open (N.O.) or normally closed (N.C.)supervised input or the polarity reversal from an FACP (Fire Alarm Control Panel). A form "C" dry output relay enables HVAC Shutdown, Elevator Recall or it may be used to trigger auxiliary devices.

• Wall mount enclosure for indoor use.
• Accommodates up to two (2) 12VDC/7AH Batteries.
• Dimensions 13"W x 13.5"H x 3.25"D (330 mm W x 343 mm H x 83 mm D).
• 1/2" and 3/4" combination knockouts.

• Input 115VAC / 60Hz, 3.5A.
• Input fuse rated @ 5A/250V.
• Fire Alarm Panel or Access Control System trigger inputs. N.O. or N.C. supervised trigger input and polarity reversal trigger input.

• 12VDC or 24VDC selectable outputs.
• 12VDC @ 4A or 24VDC @ 3A supply current
• Burglar Alarm Applications:
• 12VDC = 10VDC-13.2VDC;
• 24VDC = 20VDC-26.4VDC.
• Five (5) PTC protected Class 2 Rated power limited outputs, rated @ 2A (auto-resettable).
• Output relay energizes when unit is triggered (form "C" contact rated 1A @ 28VDC).
• Filtered and electronically regulated output.
• Short circuit and thermal overload protection.

• Built-in charger for sealed lead acid or gel type batteries.
• Automatic switch over to stand-by battery when AC fails.

• AC fail supervision (form "C" contacts).
• Notification trigger is selectable for 30 seconds (factory set) or 6 hours.
• Low battery supervision (form "C" contacts).
• Battery presence supervision (form "C" contacts).
• Power fail supervision relay (form "C" contacts).

• AC input and DC output LED indicators (power supply board).
• Red LEDs indicate condition of power outputs (multi-output board).
• Power & input trigger LEDs (multi-output board).