ELK ELK-110 Voice, Siren Driver With Temporal Coded Bell

The ELK-110 from ELK is a Voice, Siren Driver w-Temporal Coded Bell. The ELK-110 Voice "Talking" Driver features high quality digitally pre-recorded voice messages and loud attention getting siren sounds in an economical, low current draw, compact package. It features three input channels (1 for Burglar, 1 for Fire, and 1 for Carbon Monoxide), bilingual voices (English and Spanish), and many unique options which allow it to be used with virtually any residential or commercial alarm installation. The voice messages and the siren alternately sound whenever one of the channels are activated. The ELK-110 may be customized by use of on-board jumpers. For example: our MilliMiser option allows the already low current draw of the ELK-110 to be reduced even lower. This is ideal for controls with limited alarm output power. The ComboTrigger option allows controls which have a single alarm output and pulsing option to activate both the burglar and fire alarm sounds. The VolumeStep option is best described as the "peacekeeper", since it causes the siren sound to start at low volume, gradually increasing over 90 seconds to maximum volume.

Features

Installer Friendly - Compact & Easy to Mount

Three Input Channels, Burglar, Fire, and Carbon Monoxide

Bilingual Voice - English and or Spanish, Siren Only, Speech Only, or Combined

MilliMiser Lowers Current Draw

ComboTrigger For Single Outputs

VolumeStep Slowly Increases Siren Volume

Temporal 3 Coded Fire Signal

Temporal 4 Coded CO Signal

Specs

Manufacturer Elk Products Inc.

Condition New

Model ELK-110

Operating Voltage 10 to 14 Volts DC

Current Draw 1.25 Amps, (800 mA on MilliMiser setting), with one 8 Ohm speaker

Sound Level 122 db @ 1 meter, 14 vdc, with one 8 Ohm speaker

Max. Speaker Load 4 Ohms

Size 2.75" x 4.0" (70mm x 102mm)