Honeywell Fire Systems HP600ULACM8 Power Supply with Controller
Honeywell Fire Systems HP600ULACM8 Power Supply with Controller

Honeywell Fire Systems HP600ULACM8 Power Supply with Controller

0 Review(s)
Availability:
Part Number: HPP-HP600ULACM8
$326.36
Retail Price:$360.20
Your Savings:$33.84(9%)
Honeywell Power Eight Power Limited Outputs - Class 2 C
Write a Review
The HP600ULACM8 is a 12VDC or 24VDC power supply with HPACM4 or HPACM8 access power controllers to be used with Card Access Systems. They provide 12/24VDC through 4 or 8 independently controlled power-limited PTC protected outputs. They accept inputs from open collector sink or Normally Open (NO) dry contacts from UL listed security devices such as keypads, card readers, access control systems, PIR’s and Push Button Delays. Outputs from the HPACM4 and HPACM8 can switch power on or off at 12 or 24VAC/DC. Each output can be configured to respond to FACP input. The outputs can also be individually selected as isolated dry contacts (Form “C” configuration). The HPACM4 and HPACM8 can be configured for common power, which means the same supply drives both output power and control board power or alternatively, dual power input, which separates control board and output power. These units have not been evaluated for elevator equipment and are not authorized for bell output in Mercantile applications.

Features
  • Input voltage: 120VAC 60Hz; Current: 2.50A max
  • Output Voltage: 12VDC or 24VDC, jumper selectable; Current: 6.0A continuous output maximum plus battery charger (DC output not supervised)
  • Fail safe dry contact output on AC Failure (within one minute)
  • Built-in charger for sealed lead acid or gel cell type batteries
  • Instantaneous transfer to stand-by battery on AC failure
  • Battery presence detection (within 1 minute)
  • Battery low disconnect at 9.90VDC or 19.90VDC
  • High voltage disconnect at 15VDC or 30VDC
  • Yellow LED (L3) indication for battery disconnected and battery low
  • Fail safe dry contact output for Battery trouble (Fail Safe)
  • Battery polarity reversal protection
  • Thermal overload and short circuit protection
  • DC output PTC activated indication by Red LED (L2)
  • DC output failure indication by Red LED ( L4 )
  • AC presence indication by Green LED ( L1 )
  • DC output indication by Red LED ( L5 )
  • Battery Leads included
  • Power Board Dimensions: 6.2”L x 4.7”W x 2.5”H
  • Enclosure Dimension: 17”L x 13.5”W x 4.75”H. Accommodates two 12 Volt 12AH batteries. When using larger batteries, a UL approved enclosure must be used

  • Recently Viewed Items

    Customer Service available Mon - Fri 7am - 7pm EST

    Contact us: [email protected]