Linear DX-COKIT Supervised Carbon Monoxide Detector Transmitter and Receiver Kit
Linear DX-COKIT Supervised Carbon Monoxide Detector Transmitter and Receiver Kit

Linear DX-COKIT Supervised Carbon Monoxide Detector Transmitter and Receiver Kit

0 Review(s)
Availability:
Part Number: LIN-DXCOKIT
$149.91
Retail Price:$165.46
Your Savings:$15.55(9%)
Linear Llc Kit Including One Dxs80 Detector And A D
Write a Review
The DX-COKIT Supervised Carbon Monoxide Detector Transmitter and Receiver Kit contains a single station DXS-80 carbon monoxide alarm with a built-in supervised transmitter and DXR-702 2-Channel Receiver. The kit is designed to provide wireless CO detection capability for ANY hardwired alarm control panel. The DXS-80 provides a warning to alert against both the acute and chronic effects of carbon monoxide (CO) poisoning. The receiver provides a Form "C" (normally open & normally closed) relay outputs for connection to an alarm control panel. When carbon monoxide is detected, the DXS-80 sounds a loud local alarm. The built-in transmitter sends a digitally coded wireless signal to the DXR-702 receiver every 10 seconds until the air has cleared and the detector is restored. The CO alarm will activate the receiver Channel 1 relay. No field coding is required because the DXS-80 is already factory programmed into the DXR-702 receiver. The DXR-702 receiver can be powered from a 11-17 VDC or 12-16 VAC power source. A nine-inch wire whip antenna screws into the receiver's antenna connector. Optionally, a remote antenna (Model EXA-1000) can be connected to the receiver for greater radio range. The DXS-80 is powered by one 3-volt lithium battery. The battery is supplied and can power the unit for up to the six year life of the detector. If the battery voltage drops below a preset level the alarm will sound a low battery chirp every 45 seconds and a low battery signal will be sent to the receiver, activating the receiver’s Channel 2 relay. At about 6 years, the carbon monoxide detector element will reach the end of its serviceable life. The self-supervising detector will signal a permanent trouble condition, indicating time for replacement.

Features
  • DXS-80 Detector Features
  • Electrochemical type detector
  • Alarm and low battery transmissions reported by receiver
  • One 3-volt lithium battery supplied
  • Two status indicators
  • Built-in 85 dBA sounder
  • DXS format
  • RF frequency: 315 MHz
  • 5.375" W x 5.375" H x 2" D
  • DXR-702 Receiver Features
  • 32 transmitter capacity
  • RF activity indicator
  • Quick-learn programming
  • Operates on 11-17 VDC or 12-16 VAC power
  • Two channels
  • Transmitter low battery reporting
  • DX format
  • Two form "C" relay outputs
  • One Amp contact rating @ 24 Volts AC/DC
  • Selectable relay activation time
  • Current consumption: 25 mA standby, 90 mA operating @ 12 VDC
  • RF frequency: 315 MHz
  • 5.5" W x 4.0" H x 1.25" D

  • Recently Viewed Items

    Customer Service available Mon - Fri 7am - 7pm EST

    Contact us: [email protected]