Napco NPAMOD8 Access Power Controller

The NP-AMOD8 is an access power controller that distributes one (1) 12-24 volt AC or DC input over eight (8) independently controlled (and fuse protected) outputs. In addition, these 8 outputs can be configured as dry form "C" contacts. The outputs are activated by an open collector sink or normally open (NO) dry trigger input from a Card Reader, Access Control System, Push Button, Keypad, PIR, etc. It will direct power to many access control hardware devices including Electric Strikes, Magnetic Locks and Door Holders, etc. Outputs operate in both fail-secure and fail-safe modes. The NP-AMOD8 can be powered by one common power source that provides power for both the locking devices and board operation, or two totally independent power sources, one supplying power for lock / accessory power and the other for board operation. The FACP Interface enables Alarm Monitoring, Emergency Egress, HVAC Shutdown, Elevator Recall or can be used to trigger other auxiliary devices. The fire alarm disconnect can be configured for the following modes: Eight (8) outputs unaffected (Fail Safe) or Eight (8) outputs affected (Fail Secure). Each output is independent controlled.

Features

12 to 24volt AC or DC Operation (setting not required). (.5amp @ 12volt, .22amp @ 24volt current consumption with all relays energized)

Power supply input options:

a) One (1) common power input (board and lock power)

b) Two (2) isolated power inputs (one (1) for board power and one (1) for lock power)

Eight (8) Access Control System trigger inputs

Input options:

a) Eight (8) normally open (NO) inputs

b) Eight (8) open collector sink inputs

c) Any combination of the above

Eight (8) independently controlled outputs

Output options:

a) Eight (8) fail-Safe and/or fail-Secure power outputs

b) Eight (8) dry form "C" 5 amp rated relay outputs

c) Any combination of the above

Eight (8) auxiliary power outputs (unswitched)

Output fuses are rated 3. amp

Main fuse is rated at 10 amp

Red LEDs indicate outputs are triggered (relays energized)

Fire Alarm disconnect (latching or non-latching)

Fire Alarm disconnect input options:

a) Normally open (NO) or normally closed (NC) dry contact input.

b) Polarity reversal from FACP signal circuit

Fire Alarm disconnect output options:

a) Eight (8) outputs affected

b) Eight (8) outputs unaffected

FACP output relay (form "C" contact rated @ 1 amp 28VDC not evaluated by UL)

Green LED indicates when FACP disconnect is triggered

Removable terminal blocks facilitate ease of installation. Board Dimensions: 203.2mm L x 114.3mm W x 45mm H