Veracity VHWHW Highwire Ethernet over Coax Converter (Single)

The Veracity Highwire Ethernet over Coax Converter (Single) converts analog video cables into a high-speed network connection. Using the converter, you can replace analog IP cameras with IP cameras without installing any new cables. Speed, duplex, and crossover are sensed on connection of the Highwire Ethernet over Coax Converter, thus requiring no setup. No configuration is required when you connect the unit to each end of the coaxial cable, as the link will be established automatically. The Ethernet over Coax Converter is invisible to Ethernet data, and does not need a MAC or IP address. Besides auto-optimizing for all 75 ohm coaxial cables, the long connection range of the converter makes it suitable for network connections beyond 328' (100m). Featuring a universal power input, the Highwire Ethernet over Coax Converter is ideal for low-voltage installations and can also be used on legacy coaxial cables. Compared to Cat5 cables, the coaxial cables coil and bend appropriately, making the converter apt for allowing network access to elevator carriages, VoIP, security, lift panel, and other devices.

Features

High-speed Network Connection

No Configuration / Setup Required

Sensed on Connection

No MAC / IP Address Required

Auto-optimizing 75 ohm Coaxial Cables

Long Connection Range

Universal Power Input

Specs

Manufacturer Veracity Usa, Inc.

Condition New

Interface Connector type: BNC 75ohm Cable impedance: 75ohm (RG59 or similar)

Range 920' (280 m) full-rate over video-grade RG-59 (Up to 1150'/350 m depending on quality) 1150' (350 m) full-rate over RG-6 1640' (500 m) full-rate over RG-11

Network Auto-configuring for speed (10BASE-T or 100BASE-T) and duplex Use with Cat 5, Cat 5e or Cat 6 patch or crossover cables

Ethernet Connector type: RJ45 Cable type: Straight through or cross-over, auto detected Rates supported: 100BaseT / 10BaseT, full/half duplex with auto negotiation

Connector type Screw terminals with detachable plug

Power supply type IEC Class II isolated only

Operating voltage Nominal 12V DC (9-24V working range) or 24V AC (type and polarity auto detected)

Supply current 200mA (12V), 100mA (24V)

Operating temp. 14 - 122°F (-10 ~ +50ºC)

Relative humidity 85% non-condensing

Grounding Chassis should be grounded and is connected to the BNC shield

Dimensions 3.3 x 2.1 x 1" (84 x 54 x 24mm) With Connector: 4 x 2.1 x 1" (102 x 54 x 24mm)