Vicon V910PH In/Out Pendant Housing F/V910

Pendant Housing for use with V910 Roughneck dome series, compatible with SVFT-UWM, SVFT-UCM and SVFT-WM.The information in this manual covers the installation and setup of the V910-PH Pendant Housing for the Roughneck V910 Fixed-Position Camera Domes. This unit should be installed by a qualified technician using approved materials in accordance with national, state and local codes. Read these instructions through completely before attempting installation

Features

Install the selected mount using appropriate hardware for the installation surface and run the cables through it according to instruction manual for the mount

Remove the lower dome/trim ring assembly from the base of the V910 by removing the four (4) screws

Install the O ring provided in the accessory kit into the groove in the V910-PH

Align the mounting holes in the base of the V910 with the mounting holes in the V910-PH and secure with the four (4) screws and lockwashers provided in the accessory kit

Run the cables through the access hole in V910-PH and the V910. Be sure to have sufficient cable length to complete wiring

Apply pipe sealant provided to the threads of V910-PH to create a seal. Screw the V910-PH assembly onto the wall mount

Wire the V910 according Figure 2; refer to XX137 for complete instructions if necessary

Continue with the instructions in the Roughneck V910 installation manual for camera configuration

Reattach the lower dome/trim ring assembly