Viking Electronics RC-3 Remote Touch Tone Cntrlr W/3 Norm Opn Or Nrm

The RC-3 enables a standard Touch Tone phone to control up to 3 maintained ON, maintained OFF, or momentary relay contacts from a remote location. The RC-3 is fully user programmable and uses non-volatile E2 memory. Up to three RC-3’s can be daisy chained on the same line to control up to nine relays. The RC-3 features switchable 12V talk battery allowing easy installation on the trunk port. In addition, the unit can be connected directly to a C.O. line or analog PABX/KSU station. The RC-3 also features a built in pulse dialer activated by a contact closure from an alarm system, temperature sensor, etc. The RC-3 will dial the number up to three times sending alert tones indicating an emergency.

Features

User Touch Tone programmable

Non-volatile E2 memory

12 digit alarm activated pulse dialer

6 digit security code (to access programming)

6 digit access code (disable or enable for additional control security)

Switchable 12V talk battery

Relay interrogation tones

Programmable relay time delays

Cascade up to three RC-3’s to control up to nine relays

Programmable ring delay before answering

Status LED’s for relays 1, 2, 3 and the answer relay

One power adaptor can power up to three units

Specs

Manufacturer Viking Electronics, Inc.

Condition New

Power: 120V AC/12V DC 500mA UL listed adapter provided

Dimensions: 133mm x 89mm x 44mm (5.25” x 3.5” x 1.75”)

Environmental: 0°C to 32°C (32°F to 90°F) with 5% to 95% non-condensing humidity

Pulse Dialing Speed: 10 pps

Talk Battery Output: 12V DC minimum (15V nominal)

Relay contact ratings: .5A @ 125V AC/1A @ 30V DC

On hook time between alarm dialing: 2.5 seconds

Connections: (2) RJ11 jacks, 10 position screw terminal strip