Tripp-Lite SMART700HG SmartPro Medical Grade .7kVA 120V Line interactive Tower UPS, full isolation, USB & Serial ports

Tripp Lite's SMART 700HG offers medical-grade UPS protection with built-in line interactive voltage regulation, intelligent monitoring and unattended shutdown capability. UL 60601-1 listed as medical electrical equipment. Built-in isolation transformer with Faraday shield removes common mode noise while maintaining full AC surge suppression in all modes less than 100 microamps. Resistant to electrostatic discharge. Includes high quality hospital-grade plug and outlets. 700VA power handling capacity supports computers, inter-networking equipment and other critical loads during commercial power failures. Line interactive voltage regulation corrects brownouts as low as 81V and overvoltages as high as 143 back to normal 120V levels, saving battery reserves for use only during complete power failures. Includes 4 outlets, diagnostic LEDs and built-in USB & RS-232 communications ports that work with downloadable PowerAlert Software and cabling to provide automatic unattended shutdown of connected network and PC applications.

Features

Ideal UPS protection for applications in medical patient-care areas where UL 60601-1 listed medical electrical equipment is required

Built-in isolation transformer with Faraday shield offers full isolation and removes common mode noise while maintaining full AC surge suppression in all modes

Line-interactive voltage regulation corrects brownouts and overvoltages from 81 to 143 volts back to usable 120V output levels, without using battery power

Hospital-grade plug and outlets offer added degree of safety and reliability to input/output connections

Full line isolation offers a higher degree of safety and prevents operational problems in sensitive electronic equipment

Resistant to electrostatic discharge

Supports loads up to 700VA/450 watts

42 minutes half load runtime (with 350VA load), 18 minutes full load runtime (with 700VA load)

4 protected hospital-grade outlets; 6-ft. cord

RS-232 and USB monitoring ports for remote monitoring and unattended shutdown

PowerAlert unattended shutdown software available via free download from www.tripplite.com (cabling included)

Complete surge protection, line isolation and EMI/RFI noise filtering

5 diagnostic LEDs indicate AC present, on battery, voltage correction, overload & battery low/replace

Battery replacement door

Grounding lug

Specs

Manufacturer Tripp-Lite

Condition New

Output Volt Amp Capacity (VA) 700

Output Watt Capacity (watts) 450

Output power factor 0.6

Nominal Output Voltage(s) Supported 115V; 120V

Frequency compatibility 60 Hz

Output voltage regulation (line mode) -18%, +8%

Output voltage regulation (Battery mode) 115V (+/- 5%)

Built-in UPS output receptacles 4 5-15R outlet(s)

Output receptacle details Hospital grade output receptacles

Output AC waveform (AC mode) Sine wave

Output AC waveform (battery mode) PWM sine wave

Rated input current (at maximum load) 5.5A

Nominal Input Voltage(s) Supported 120V AC

UPS input connection type 5-15P-HG

Input circuit breaker 10A

UPS Input cord length (ft.) 6

UPS Input cord length (m) 1.8

Recommended Electrical Service 15A 120V

Input cord length (ft.) 6

Input cord length (m) 1.8

Operating Temperature Range +32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius

Storage Temperature Range +5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius

Relative Humidity 0 to 95%, non-condensing

AC mode BTU / hr. (full load) 97.7